fitting line造句
例句與造句
- The pipes and fittings lined with metal meshed - ptfe
金屬網聚四氟乙烯復合管與管件 - Best - fit line
最佳擬合線 - Best fit line
最優擬合線 - Steel flanged pipes and steel and cast iron flanged fittings lined with ptfe or pfa - technical specifications
帶聚四氟乙烯或pfa襯里的鋼制法蘭管道和鋼制與鑄鐵法 - The found edge points are then applied to the line fitting tool which fits an infinite length line to the points . the fitted line is hown in figure 6
將找到的邊緣點應用于擬合工具，進而形成一條無限長的直線。擬合后的直線如圖六所示。 - It's difficult to find fitting line in a sentence. 用fitting line造句挺難的
- The attempts using k - l transform to fit line and introducing a new expression of the ellipse parameters improve the robustness and decrease the complexities of the algorithms
在吸取有關文獻的基礎上采用k - l變換進行直線擬合，提高了擬合魯棒性和精度。 - Then a fast computing method is presented to estimate the curvature of edge points and the points at which curvature is less than some threshold are collected to fit lines
為提取直線邊緣，使用改進的序列細化算法將邊緣細化為單像素寬，而后用一種快速曲率估計方法估算邊緣點的曲率，并保留估算值很?。s等于零）的點擬合直線。 - If a higher accuracy resolution is required , the distances of points to the fitting line can be taken as the judgment standard , and the data eliminated noise points by hough transform can be simulated by the least square method
當精度要求較高時，可將各擬合點到擬合直線的距離作為判別標準，對經霍夫變換剔除干擾點（或噪聲）后的數據點再進行最小二乘法擬合。 - First , this method decide the skew angle of a business card image according to four border fitting lines of the business card , then a method based on block move is provided to correct image and black border is erased based on position of border near - line
該方法先檢測出名片的四條邊緣擬合直線，由四條邊緣擬合直線的傾斜角度來確定名片圖像傾斜角度，然后采用逐段整塊搬移的方法來對圖像進行傾斜校正，再根據邊緣擬合直線位置去除黑邊。 - By studying the characteristics of the eddy displacement sensor , it adopts the control method which include using the fitting line of sensor ' s output characteristic curve in certain block as control characteristic curve , and stipulating door limit district and a certain of backward overshoot , the stabilization of welding torch is gained under the certain track precision
摘要通過對渦流式位移傳感器的特性研究，采用以傳感器輸出特性曲線在一定區間內的擬合直線作為控制特性曲線、設定規定門限區和一定反向調節量的控制方法，得到了在保證一定的跟蹤精度條件下的焊槍穩定。